Dell PowerEdge FX2/FX2s - Manual (Page 369)

Last Change
----------- ------- -----------
-----------
*S 0.0.0.0/0 via 10.10.91.9, Te 1/2 1/0
3d2h
Dell#
Layer 2
This chapter describes commands to configure Layer 2 features.
This chapter contains:
• MAC Addressing Commands
MAC Addressing Commands
The following commands are related to configuring, managing, and viewing MAC addresses.
mac-address-table aging-time
Specify an aging time for MAC addresses to remove from the MAC address table.
Syntax mac-address-table aging-time seconds
To delete the configured aging time, use the no mac-address-table aging-
time seconds command.
Parameters
seconds Enter either zero (0) or a number as the number of seconds
before MAC addresses are relearned. To disable aging of the
MAC address table, enter 0. The range is from 10 to
1000000. The default is 1800 seconds.
Defaults 1800 seconds
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
mac-address-table static
Associate specific MAC or hardware addresses to an interface and virtual local area networks (VLANs).
Syntax mac-address-table static mac-address output interface vlan
vlan-id
To remove a MAC address, use the no mac-address-table static mac-
address output interface vlan vlan-id command.
369