Dell PowerEdge FX2/FX2s - Manual (Page 340)

Command
Modes INTERFACE
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.
iSCSI Optimization
Internet small computer system interface (iSCSI) optimization enables quality-of-service (QoS) treatment
for iSCSI storage traffic.
To configure and verify the iSCSI optimization feature, use the following Dell Networking Operating
System (OS) commands.
advertise dcbx-app-tlv
Configure DCBX to send iSCSI TLV advertisements.
Syntax advertise dcbx-app-tlv iscsi
To disable DCBX iSCSI TLV advertisements, use the no advertise dcbx-app-
tlv iscsi command.
Defaults Disabled.
Command
Modes PROTOCOL LLDP
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information You can configure iSCSI TLVs to send either globally or on a specified interface.
The interface configuration takes priority over global configuration.
iscsi aging time
Set the aging time for iSCSI sessions.
Syntax iscsi aging time time
To remove the iSCSI session aging time, use the no iscsi aging time
command.
Parameters
time Enter the aging time for the iSCSI session. The range is from
5 to 43,200 minutes.
340