System-mac, Unit-id – Dell PowerEdge FX2/FX2s User Manual
Page 458
Vlan IPV4 Multicast Status
--------------------------
Vlan-ID Local Status Peer Status
-------- ------------ -----------
4094 Active Inactive
Dell#
system-mac
Reconfigure the default MAC address for the domain.
Syntax
system-mac mac-address
Parameters
mac-address
Enter the system MAC address for the VLT domain.
Defaults
Not configured.
Command
Modes
VLT DOMAIN
Command
History
Version 9.4(0.0)
Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
When you create a VLT domain on a switch, Dell Networking OS automatically
creates a VLT-system MAC address used for internal system operations.
To reconfigure the default MAC address for the domain by entering a new MAC
address in the format nn:nn:nn:nn:nn:nn, use the system-mac command.
You must also reconfigure the same MAC address on the VLT peer switch.
unit-id
Explicitly configure the default unit ID of a VLT peer switch.
Syntax
unit-id [0 | 1]
Parameters
0 | 1
Configure the default unit ID of a VLT peer switch. Enter 0
for the first peer or enter 1 for the second peer.
Defaults
Automatically assigned based on the MAC address of each VLT peer. The peer with
the lower MAC address is assigned unit 0; the peer with the higher MAC address is
assigned unit 1.
Command
Modes
VLT DOMAIN
Command
History
Version 9.4(0.0)
Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
458