Dell PowerEdge FX2/FX2s - Manual (Page 400)

Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS
using policy maps.
service-policy output — applies an output policy map to the selected interface.
qos-policy-output
Create a QoS output policy.
Syntax qos-policy-output qos-policy-name
To remove an existing output QoS policy, use the no qos-policy-output qos-
policy-name command.
Parameters
qos-policy-
name Enter your output QoS policy name in character format (32
characters maximum).
Defaults none
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
To specify the name of the output QoS policy, use this command. After the output
policy is specified, rate-limit, bandwidth-percentage, and WRED can be defined.
This command enables Qos-Policy-Output Configuration mode — (conf-qos-
policy-out).
Related
Commands
bandwidth-percentage — assigns weight to the class/queue percentage.
rate-shape
Shape the traffic output on the selected interface.
Syntax rate shape [kbps] rate [burst-KB]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits
per second (Kbps). Make the following value a multiple of 64.
The range is from 0 to 40000000. The default granularity is
Megabits per second (Mbps).
rate Enter the outgoing rate in multiples of 10 Mbps. The range is
from 10 to 10000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 0 to
10000. The default is 50.
400