Dell PowerEdge FX2/FX2s - Manual (Page 304)

Parameters
priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Defaults 0x10
Command
Modes PROTOCOL LLDP
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information This command is available at the global level only.
priority-group bandwidth pfc
Configure the ETS bandwidth allocation and PFC mode used to manage port traffic in an 802.1p priority
group.
I/O Aggregator
Syntax priority-group group-num {bandwidth percentage| strict-
priority} pfc {on | off}
Parameters
priority-group
group-num Enter the keyword priority-group followed by the
number of an 802.1p priority group. Use the priority-
pgid command to create the priority groups in a DCB map.
bandwidth
percentage Enter the keyword bandwidth followed by a bandwidth
percentage allocated to the priority group. The range of valid
values is 1 to 100. The sum of all allocated bandwidth
percentages in priority groups in a DCB map must be 100%.
strict-priority Configure the priority-group traffic to be handled with strict
priority scheduling. Strict-priority traffic is serviced first,
before bandwidth allocated to other priority groups is made
available.
pfc {on | off} Configure whether priority-based flow control is enabled
(on) or disabled (off) for port traffic in the priority group.
Defaults None
Command
Modes DCB MAP
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
Use the dcb-map command to configure priority groups with PFC and/or ETS
settings and apply them to Ethernet interfaces.
Use the priority-pgid command to map 802.1p priorities to a priority group.
You can assign each 802.1p priority to only one priority group. A priority group
304