Trace route – Dell PowerEdge FX2/FX2s User Manual
Page 84
trace route
View the packet path to a specific device.
Syntax
traceroute {host | ip-address}
Parameters
host
Enter the name of device.
ip-address
Enter the IP address of the device in dotted decimal format.
Defaults
Timeout = 5 seconds; Probe count = 3; 30 hops max; 40 byte packet size; UDP
port = 33434
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4(0.0)
Supported on the FN I/O aggregator.
Usage
Information
When you enter the traceroute command without specifying an IP address
(Extended Traceroute), you are prompted for a target and source IP address,
timeout in seconds (default is 5), a probe count (default is 3), minimum TTL (default
is 1), maximum TTL (default is 30), and port number (default is 33434). To keep the
default setting for those parameters, press the ENTER key.
Example (IPv4)
Dell#traceroute www.force10networks.com
Translating "www.force10networks.com"...domain server
(10.11.0.1) [OK]
Type Ctrl-C to abort.
---------------------------------------------------------------
------------------
---------
Tracing the route to www.force10networks.com (10.11.84.18), 30
hops max, 40 byte
packets
---------------------------------------------------------------
------------------
---------
TTL Hostname Probe1 Probe2 Probe3
1 10.11.199.190 001.000 ms 001.000 ms 002.000 ms
2 gwegress-sjc-02.force10networks.com (10.11.30.126) 005.000
ms 001.000 ms
001.000 ms
3 fw-sjc-01.force10networks.com (10.11.127.254) 000.000 ms
000.000 ms 000.000
ms
4 www.force10networks.com (10.11.84.18) 000.000 ms 000.000 ms
000.000 ms
Dell#
Related
Commands
— Tests the connectivity to a device.
84