Dell PowerEdge FX2/FX2s - Manual (Page 196)

Parameters
stack-unit
unit_number (REQUIRED) Enter the keyword stack-unit followed by a
stack member number to select the stack unit for which to
gather information. The range is 0 to 5.
port-set port-
pipe (REQUIRED) Enter the keywords port-set followed by a
Port-Pipe number to select the Port-Pipe for which to gather
information. The range is 0.
address mac-
addr (OPTIONAL) Enter the keyword address followed by a MAC
address in the nn:nn:nn:nn:nn:nn format to display
information on that MAC address.
dynamic (OPTIONAL) Enter the keyword dynamic to display only
those MAC addresses learned dynamically by the switch.
static (OPTIONAL) Enter the keyword static to display only those
MAC address specifically configured on the switch.
interface
interface (OPTIONAL) Enter the keyword interface followed by the
interface type, slot and port information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN
ID to display the MAC address assigned to the VLAN. The
range is from 1 to 4094.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
196