Dell PowerEdge FX2/FX2s - Manual (Page 329)

When restoring units in stand-alone mode, the units remin in stand-alone mode
after the restoration. After the restore is complete, the units power cycle
immediately.
CAUTION: There is no undo for this command.
Example
Dell#restore factory-defaults stack-unit 0 clear-all
**************************************************************
* Warning - Restoring factory defaults will delete the
existing *
* startup-config and all persistent settings (stacking,
fanout, etc.)*
* After restoration the unit(s) will be powercycled
immediately. *
* Proceed with caution ! *
**************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
0 Success Success
Power-cycling the unit(s).
Dell#
Example
(NvRAM, all)
Dell#restore factory-defaults stack-unit all nvram
**************************************************************
* Warning - Restoring factory defaults will delete the
existing *
* persistent settings (stacking, fanout, etc.) *
* All the units in the stack will be split into standalone
units. *
* After restoration the unit(s) will be powercycled
immediately. *
* Proceed with caution ! *
**************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
0 Success
1 Success
2 Success
3 Not present
4 Not present
5 Not present
Power-cycling the unit(s).
Dell#
Example
(NvRAM, single
unit)
Dell#restore factory-defaults stack-unit 1 nvram
**************************************************************
* Warning - Restoring factory defaults will delete the
existing *
* persistent settings (stacking, fanout, etc.) *
* After restoration the unit(s) will be powercycled
immediately. *
* Proceed with caution ! *
**************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
329