Dell PowerEdge FX2/FX2s - Manual (Page 385)

Parameters
priority Enter the priority assigned to the FN 2210S Aggregator NPIV
proxy gateway, which appears to a downstream server CNA
as an FCF. The range of FCF priority values is from 1 to 255.
Defaults 128
Command
Modes FCOE MAP
Command
History
Version 9.6(0.0) Supported on the FN 2210S Aggregator.
Version 9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module.
Usage
Information
The FCF priority you assign to an FN 2210S Aggregator is used by server CNAs to
select an upstream FCF to use for a fabric login (FLOGI).
To remove a configured FCF priority from an FCoE map, enter the no fcf-
priority command.
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the
communication between servers and a SAN fabric.
show fcoe-map displays the Fibre Channel and FCoE configuration parameters in
FCoE maps.
fka-adv-period
In an FCoE map, configure the time interval used to transmit FIP keepalive (FKA) advertisements.
Syntax fka-adv-period seconds
Parameters
seconds Enter the time period (in seconds) used to send FIP keepalive
messages to peer devices. The range is from 8 to 90
seconds.
Defaults 8 seconds
Command
Modes FCoE MAP
Command
History
Version 9.6(0.0) Supported on the FN 2210S Aggregator.
Version 9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module.
Usage
Information
To delete the FIP keepalive time period from an FCoE map, enter the no fka-
adv-erpiod command.
385