Dell PowerEdge FX2/FX2s - Manual (Page 424)

| Pipe through a command
<cr>
Dell#show system stack-unit 0 stack-group configured
Configured stack groups in stack-unit 0
Dell#show system stack-unit 0 stack-group
Stack group Ports
------------------------------------
0 0/9
1 0/10
2 0/11
3 0/12
Dell#
Related
Commands
reload — reboots the system.
show system — displays the current status of all stack members or a specific
member.
stack-unit priority
Configure the ability of a switch to become the management unit of a stack.
Syntax stack-unit stack-number priority 1-14
Parameters
stack-number Enter the stack member unit identifier.
1–14 This preference parameter allows you to specify the
management priority of one backup switch over another,
with 0 the lowest priority and 14 the highest. The switch with
the highest priority value is chosen to become the
management unit if the active management unit fails or on
the next reload.
Defaults 0
Command
Modes CONFIGURATION
Command
History
Version 9.6.
(0.0) Introduced on the FN I/O Aggregator.
Usage
Information This command is supported on the FN410S and the FN410T Aggregators.
Related
Commands
• reload – reboots Dell Networking Operating System (OS).
• show system – displays the status of all stack members or a specific member.
stack-unit renumber
Change the stack member ID of any stack member or a stand-alone unit.
Syntax stack-unit 0-5 renumber 0-5
424