Dell PowerEdge FX2/FX2s - Manual (Page 342)

iscsi enable
Globally enable iSCSI optimization.
Syntax iscsi enable
To disable iSCSI optimization, use the no iscsi enable command.
Parameters
enable Enter the keyword enable to enable the iSCSI optimization
feature.
Defaults Disabled.
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information When you enable the iSCSI feature using the iscsi enable command, flow
control settings are set to rx on tx off on all interfaces.
iscsi priority-bits
Configure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs.
Syntax iscsi priority-bits priority-bitmap
To remove the configured iSCSI priority, use the no iscsi priority-bits
command.
Parameters
priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Defaults 0x10
Command
Modes PROTOCOL LLDP
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information This command is available at the global level only.
iscsi profile-compellent
Configure the auto-detection of Dell Compellent arrays on a port.
Syntax iscsi profile-compellent
342