Dell PowerEdge FX2/FX2s - Manual (Page 97)

Usage
information If you do not use the statistics parameter, both hardware and DCBx counters
clear.
dcb enable auto-detect on-next-reload
Enables or disables global DCB on a subsequent reload. This command also internally configures PFC
buffers based on DCB enable/disable. Save and reload is mandatory for the configurations to take effect.
Auto-detect keyword can be used to re-enable IOA with port wise DCB auto detect feature.
Syntax dcb enable [auto-detect | on-next-reload]
To disable global DCB on a subsequent reload, use the no dcb enable on-
next-reload command.
Parameters
auto-detect Enter the keywords auto-detect to re-enable the
Aggregator with port wise DCB auto detect feature.
on-next-reload Enter the keywords on-next-reload to apply DCB
configurations on subsequent reload.
Defaults DCB is globally enabled with auto-detect feature.
Command
Modes
• CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Example
(Disable)
Dell#show dcb stack-unit 0 port-set 0
stack-unit 0 port-set 0
DCB Status: Enabled, PFC Queue Count: 4
stack-unit Total Buffer PFC Total Buffer PFC Shared Buffer PFC
Available Buffer
PP (KB) (KB)
(KB) (KB)
---------------------------------------------------------------
-------------------
0 0 3822 1912 832
450
Dell(conf)#
Dell#
Dell#
Dell#conf
Dell(conf)#no dcb enable on-next-reload
Dell(conf)#end
Dell#
Dell#write memory
!
Mar 18 00:21:49: %STKUNIT0-M:CP %FILEMGR-5-FILESAVED: Copied
running-config to startup-config in flash by default
Dell#reload
97