Dell PowerEdge FX2/FX2s - Manual (Page 399)

Parameters
qos-policy-
name Enter the name of the policy map in character format (32
characters maximum).
Defaults none
Command
Modes CONFIGURATION (policy-map-input and policy-map-output)
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
Aggregate input/output QoS policy applies to all the port ingoing/outgoing traffic.
Aggregate input/output QoS policy can coexist with per queue input/output QoS
policies.
1. If only aggregate input QoS policy exists, input traffic conditioning
configurations (rate-police) apply. Any marking configurations in aggregate
input QoS policy are ignored.
2. If aggregate input QoS policy and per class input QoS policy coexist,
aggregate input QoS policy preempts per class input QoS policy on input
traffic conditioning (rate-police). In other words, if rate police configuration
exists in the aggregate QoS policy, the rate police configurations in per class
QoS are ignored. Marking configurations in per class input QoS policy still
apply to each queue.
Related
Commands
policy-map-output — creates an output policy map.
policy-map-output
Create an output policy map.
Syntax policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name
command.
Parameters
policy-map-
name Enter the name for the policy map in character format (32
characters maximum).
Defaults none
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information To assign traffic to different flows using QoS policy, use the Output Policy map.
This command enables Policy-Map-Output Configuration mode (conf-policy-
map-out).
399