Dell PowerEdge FX2/FX2s - Manual (Page 392)

Fabric Intf : Fc 0/0
FCoE Vlan : 1003
Fabric Map : fid_1003
ENode WWPN : 10:00:00:00:c9:d9:9c:cb
ENode WWNN : 10:00:00:00:c9:d9:9c:cd
FCoE MAC : 0e:fc:03:01:02:02
FC-ID : 01:02:01
LoginMethod : FDISC
Secs : 5593
Status : LOGGED_IN
Related
Commands
dcb-map — creates a DCB map to configure DCB parameters on Ethernet ports
that support converged Ethernet traffic.
fcoe-map — creates an FCoE map which contains the parameters used in the
communication between servers and a SAN fabric.
show interfaces status
Displays a summary of interface information or specify a stack unit and interface to display status
information for that specific interface only.
Syntax show interfaces [interface | stack-unit unit-number] status
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
linecard slot-
number (OPTIONAL) Enter the keyword linecard then the slot
number.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.6(0.0) Supported on the FN 2210S Aggregator.
Version 9.4(0.0) Supported on the FN I/O aggregator.
Example
Dell#show interface status
Port Description Status Speed Duplex Vlan
Te 0/1 Up 10000 Mbit Full 1-4094
Te 0/2 Up 10000 Mbit Full 1-4094
Te 0/3 Up 10000 Mbit Full 1-4094
Te 0/4 Up 10000 Mbit Full 1-4094
Te 0/5 Up 10000 Mbit Full --
Te 0/6 Up 10000 Mbit Full 1-4094
Te 0/7 Up 10000 Mbit Full --
Te 0/8 Up 10000 Mbit Full --
Te 0/9 Up 10000 Mbit Full --
392