Dell PowerEdge FX2/FX2s - Manual (Page 410)

banner exec
Configure a message that is displayed when your enter EXEC mode.
Syntax banner exec c line c
To delete a banner, use the no banner exec command.
Parameters
c Enter the keywords banner exec, then enter a character
delineator, represented here by the letter c. Press ENTER.
line Enter a text string for your banner message ending the
message with your delineator. In the following example, the
delineator is a percent character (%); the banner message is
“testing, testing”.
Defaults No banner is displayed.
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information After entering the banner login command, type one or more spaces and a
delineator character. Enter the banner text then the second delineator character.
When the user is connected to the router, if a message of the day banner is
configured, it displays first. If no message of the day banner is configured, the login
banner and prompt appear. After the user has logged in, the EXEC banner (if
configured) displays.
Example
Dell(conf)#banner exec ?
LINE c banner-text c, where 'c' is a delimiting character
Dell(conf)#banner exec %
Enter TEXT message. End with the character '%'.
This is the banner%
Dell(conf)#end
Dell#exit
4d21h5m: %RPM0-P:CP %SEC-5-LOGOUT: Exec session is terminated
for user on line
console
This is the banner
Dell con0 now available
Press RETURN to get started.
4d21h6m: %RPM0-P:CP %SEC-5-LOGIN_SUCCESS: Login successful for
user on line
console
This is the banner
Dell>
Related
Commands
banner login — sets a banner for login connections to the system.
exec-banner — enables the display of a text string when you enter EXEC mode.
410