Axel AX3000 65 User's Manual - Manual (Page 131)

Installing under OS/400
AX3000 - User's Manual
119
6.4.4 - Setting-Up the AX3000
No OS/400 command allows the contents of a set-up file to be sent over the
network. The following example describes the use of rsh Windows command:
c:\> rsh 192.168.1.241 setup_send password < /tmp/axel
Where:
- 192.168.1.241 : AX3000 IP address,
- setup_send : command for set-up the AX3000,
- password
: specify the set-up password if set.
For more information about this command, refer to Chapter 10.
6.4.5 - Downloading a Firmware
To download an AX3000 firmware through TFTP:
===> RUNRMTCMD CMD('AX_DOWNLOAD password /axfirm/ax3000 192.168.1.180')
RMTLOCNAME('192.168.1.241' *IP)
To download an AX3000 firmware through BOOTP and TFTP:
===> RUNRMTCMD CMD('AX_DOWNLOAD password /axfirm/ax3000 192.168.1.180')
Parameters of the RUNRMTCMD command:
- AX_DOWNLOAD : command for firmware downloading,
- password : specify the password if the set-up is password-
protected,
- /axfirm/ax3000 : path and name of the firmware file,
- 192.168.1.180 : AS/400 IP address,
- 192.168.1.241 : AX3000 IP address.
Messages are displayed on the target AX3000 (See Chapter 11.4).
6.4.6 - Editing AX3000 Statistics
Some AX3000 statistics can be obtained by invoking the following command:
===> RUNRMTCMD CMD(AX_GETSTAT) RMTLOCNAME('192.168.1.241' *IP)