Axel AX3000 65 User's Manual - Manual (Page 262)

Appendix
250
AX3000 - User's Manual
The parameters are:
- The IP address or DNS name of the AxRM server
- The TCP port AxRM is listening on
Having two parameters is not mandatory nor is the order important. For
example you may only need to enter the IP address if the default port 80 is
being used.
The table below gives examples:
AxRM Network Location
IP address TCP port
axrmserv:mypc:82
"mypc" DNS resolution 82
axrmserv:82
The IP address will be given by
the method 2 or 3 (see chapter
2.1). 82
axrmserv:192.168.0.1
192.168.0.1 80
A.7 - SETTING THE IP ADDRESS BY A PING COMMAND
A new feature with version ‘e’ firmware enables the system manager to
remotely assign an initial IP address to a brand new terminal, or remotely
change an existing IP address.
The procedure is to manually modify the ARP table of your computer (Unix,
Linux, Windows...). An ARP table entry is composed of IP addresses and
Ethernet MAC addresses. The command below associates an arbitrary IP
address to the terminal’s hard coded MAC address. The MAC address is
printed on the base of each terminal. With its updated ARP table your computer
is able to access the AX3000.To set the new IP address the terminal must be
pinged twice.
Using under Unix/Linux:
Run the following command to associate the AX3000’s Ethernet address
xx:xx:xx:xx:xx:xx with the IP address a.b.c.d (this command updates the ARP