Axel AX3000 65 User's Manual - Manual (Page 164)

Installing under Windows
152
AX3000 - User's Manual
Within the 'Session Profile' box, select 'Aux. Port Redirection' and press
<Space>. The following box is displayed:
These parameters are:
- AuxX Port Redirection: set the redirection function for this auxiliary port.
- TSE Port Name: not available for ICA connection.
- DSR Signal: the DSR signal is not supported by the AX3000. This
parameter allows the incoming DSR value to be emulated. The possible
values are: "Always Low", "Always Up", "Follows CTS" or "Follows CD".
When enabled within the terminal setup Aux1 and Aux2 ports are mapped to
COM1 and COM2. The administrator must then manually map these COM ports
to ‘unused’ server COM ports using the "change client" or "net use"
commands. These commands are issued from a command prompt from the
terminal’s Citrix session.
Example: the Windows COM4 port is remapped to the terminal COM1 port
net use com4: \\client\com1:
or
change client com4: com1:
Note: this remapped resource is only for the terminal. In this example COM4 is
not seen by other users.
☺ : how to set-up a user account to automatically launch a "net use" command.
- Create a shareable directory called Netlogon.
- In this directory create a file called "myscript.bat".
- Enter the 'net use' command line as required in this file.
- Edit the user account properties by selecting the 'profile' tab and set the
"Logon script" to read the "myscript.bat" file.