Axel AX3000 65 User's Manual User Manual
Page 204
Remote Set-Up
192
AX3000 - User's Manual
ERR 103: trailer label not found. Default factory set-up reloaded
Command:
setup_send
Cause:
the trailer label (END_AX_SETUP) is not found. (Either this
label is not included in the configuration file or the
connection failed).
Consequence: the default factory set-up is reloaded (to replace the
inconsistent configuration caused by the missing trailer
label).
Solution:
add this label to the end of file and run the command again.
ERR 104: Can not get complete set-up (rcmd command aborted).
Command:
setup_get
Cause:
a network problem has occurred or the command has been
killed or aborted.
Consequence: the set-up obtained by the command is invalid (the trailer
label is missing).
Solution:
run the command again.
ERR 105: invalid rcmd command.
Command:
---
Cause:
the keyword is unknown.
Consequence: no effect.
Solution:
use the correct keyword (setup_send, setup_get or
ax_reboot).
ERR 106: cmos busy.
Command:
setup_send
Cause:
another command (setup_get or setup_send) is running, or
another user has entered set-up on the target AX3000.
Consequence: no effect.
Solution:
Either wait for a few seconds and repeat the command, or
arrange for the other user to exit set-up on the target
AX3000.