Axel AX3000 65 User's Manual - Manual (Page 206)

Remote Set-Up
194
AX3000 - User's Manual
ERR 203: xxx: no place to store udk value.
Command: setup_send
Cause: not enough memory to store the udk_xxx parameter (udk
stands for User-Defined Key; a function key for example).
Consequence: the default value of this udk parameter is restored.
ERR 204: line(s) after the trailer label ignored.
Command: setup_send
Cause: END_AX_SETUP is not the last line of the file.
Consequence: the lines after the trailer label are ignored. The AX3000 set-
up is updated.
Solution: delete these lines.
ERR 211: service name/number error. Service(s) may be reset.
Command: setup_send
Cause: Other services, such as print or tty, use the same identifier
(TCP port or name).
Consequence: to get a consistent configuration, some services have been
removed.
Solution: check service identifier values.
ERR 212: host error. Host(s) may be reset.
Command: setup_send
Cause: host parameters are missing or two host names are
identical.
Consequence: to get a consistent configuration, some hosts may have been
removed.
Solution: check the host configuration.
ERR 213: too many sessions or pages. Page number set to 1.
Command: setup_send
Cause: eight screens are supported by the AX3000. This resource is
shared by sessions and pages (i.e. multi_nbsession ∗
multi_nbpage ≤ max. session).
Consequence: to get a consistent configuration, the multi_nbpage
parameter is set to one.