Axel AX3000 65 User's Manual - Manual (Page 34)

Interactive Set-Up
22
AX3000 - User's Manual
Chapter 3.1.1) the 'Default Domain' parameter is automatically set and cannot
be accessed here.
c) Publishing the Terminal Name
The parameter "DNS Server Update" sets the method used for publishing the
terminal name:
- No: the terminal name is not published
- By the DHCP server (available only if the DHCP protocol is enabled -
see Chapter 3.1.1): the terminal name is registered by the DHCP server.
Requirement: the DDNS function (Dynamic DNS) must be supported by
the DHCP server. See Appendix A.4.3.
- By the terminal: the terminal updates the DNS server.. In this case the
parameter "If my FQDN already exists" controls the terminals behavior in
event of an error during the DNS server update (see Appendix A.4.3).
3.1.3 - Host Management
A host is a TCP/IP machine (UNIX, AS/400, etc) to which the AX3000 can open
connections (telnet, tty and VNC).
To configure the host table, select the [Configuration]-[TCP/IP]-[Hosts] menu.
A dialog box as shown below is displayed:
The host server definition depends on whether or not DNS is enabled (see