Axel AX3000 65 User's Manual - Manual (Page 263)

Appendix
AX3000 - User's Manual
251
table):
# arp -s a.b.c.d xx:xx:xx:xx:xx:xx
Run a ping command:
$ ping a.b.c.d
The first ping requests are not acknowledged. But after few seconds the
AX3000 is rebooted and replies the ping requests. The AX3000 is now set with
the a.b.c.d IP address.
Using under Windows:
☺ : Windows administration s/w (AxRM or Axel Remote Management) is
available free on the Axel Web site. See Chapter 8.8.
The procedure is the same as Unix/Linux except for the Ethernet address
notation ('-' are used as separators instead of ':'). The command is:
C:\> arp -s a.b.c.d xx-xx-xx-xx-xx-xx
Run one or more ping commands (4 ping requests are sent by ping command):
C:\> ping a.b.c.d
Note: if required this function can be disabled by setting the 'IP Addr. Set by
Ping' parameter to 'no'. For more information, refer to Appendix A.9.6.
A.8 - ADMINISTRATION COMMAND LIST
Several administration commands are offered by the AX3000. These
commands are launched by using a remote administration command (rsh for
example) which is available as standard features from most major operating
systems.