Axel AX3000 65 User's Manual - Manual (Page 244)

Appendix
232
AX3000 - User's Manual
Note: if a configuration file is obtained from an AX3000, undefined hosts and
routers are commented out.
Router explanation:
- The "tcp_router%_ip" parameter is the router IP address, the
"tcp_router%_target" parameter is the target host (or network) IP address
and the "tcp_router%_mask" parameter is an optional network mask
used to reach the target network.
- The default router is encoded by "tcp_router%_ip" set to "0.0.0.0",
"tcp_router%_target" set to "default" and "tcp_router%_mask" set to
"0.0.0.0".
Auxiliary Ports and Logical Ports Parameters
a) AUX1 and AUX2 Ports
In the following section of the file, for ease of reading the auxiliary port number
(1 or 2) has been represented by the '%' character. In a real configuration file,
the parameters for each auxiliary port would, of course, be listed.
aux%_service=none (none | rtty | printd | lpd
rcmd | rtelnet | tty | Prt5250)
aux%_service_name=aux1 (character string, 8 char max.)
aux%_associate_host=vangogh (character string, 64 char max.)
aux%_service_tcpport=23 (number)
aux%_associate_term=ansi
(character string, 8 char max.)
aux%_associate_autoconn=yes (yes | no)
aux%_associate_reconn=yes (yes | no)
aux%_rtty_accept=no (yes | no)
aux%_filter_nl=no (yes | no)
aux%_preprint_string= (character string, 48 char max.)
aux%_postprint_string= (character string, 48 char max.)
aux%_associate_devname=PRN (character string, 10 char max.)
aux%_associate_msgqname=QSYSOPR (character string, 10 char max.)
aux%_associate_msgqlib=*LIBL
(character string, 10 char max.)
aux%_associate_font=11 (character string, 10 char max.)
aux%_associate_mfrtypmdl=*NONE (character string, 10 char max.)
aux%_associate_pprsrc1=
(character string, 10 char max.)
aux%_associate_pprsrc2=*NONE (character string, 10 char max.)