Axel AX3000 65 User's Manual - Manual (Page 202)

Remote Set-Up
190
AX3000 - User's Manual
Notes:
- The next chapter explains how to create the configuration file conf_file,
either using a text editor or using the 'setup_get' command on an
existing terminal. Appendix A.5 contains a detailed description of the
configuration file.
- password: specify the password if the set-up is password-protected.
The message 'Store set-up in progress...' is displayed on the
operator’s console while the remote command is processing. If a connection
problem occurs, a time-out error message is displayed.
When the configuration has been successfully completed, the message 'OK,
set-up updated' is displayed on the operator’s console. If other messages
are displayed, refer to Chapter 10.2.3.
The AX3000 must read this new set-up before it will take effect. This can be
achieved either by power-cycling the AX3000 or by the following 'ax_reboot'
command. Example for Unix/Linux:
# rsh axname ax_reboot password
Note about password: specify the password if the set-up is password-
protected.
The message 'Reboot in progress...' is then displayed on the operator’s
console, the AX3000 is reset and the new set-up is implemented. If a
connection problem occurs, a time-out error message is displayed.
10.2.2 - Obtaining a Configuration
To obtain the configuration from an existing AX3000 terminal, use the
'setup_get' command (or 'setup_get_lite' command). This command sends a
list of all AX3000 parameters to standard output. Example for Unix/Linux:
# rsh axname setup_get > /tmp/file<CR>
The message 'Load set-up in progress...' is displayed on the
operator’s console when the rsh command is processing. If a connection
problem occurs a time-out error message is displayed.