Axel AX3000 65 User's Manual - Manual (Page 184)

Installing under Windows
172
AX3000 - User's Manual
If the operating system doesn't provide an automatic procedure to allow
sessions to time out, these 'phantom' connections will stay alive until the
operating system is rebooted.
To avoid this scenario there are two possible methods:
- using a time-out to close idle session - See Chapter 8.4.3,
- manually disconnecting the phantom session(s) - See Chapter 8.4.7.
8.5.5 - In Event of Connection Problems
The main issue at the connection time is license problem. The license possible
errors are:
1. No more TSE Cal are available: new CAL must be bought.
2. The Axel terminal had been already connected to another TSE server. In this
case, the
license token stored by the Axel terminal is not compliant with this
server. To reset the Axel "L icense Store", enter the AX3000 Set-Up, select
[Configuration]-[Advanced]-[More]-[Licence store]. The displayed dialog box
allow you to delete the current
license token(s).
Note: if this option is not available, select the '?' on the upper-right corner and
press <Ctrl><Alt><Shift><R> (or <F12> from the telnet set-up).
3. The Windows server doesn't convert a temporary license to a 'standard'
license. The server must be updated:
- for Windows 2003, install Service Pack 1.
- for Windows 2000, please consult
http://support.microsoft.com/default.aspx?scid=kb;en-us;827355
8.6 - MANAGING PRINTERS
Auxiliary ports (2 serial and 1 parallel) and logical ports (USB and TCP) are
provided by the AX3000. These ports are independently controlled so multiple
printers can be attached to the AX3000.
The AX3000 offers an embedded LPD protocol. This protocol is available in
most operating systems and allows one or more printers connected to the