Power and control connections view, Caution! disconnect power before replacing fuse – Rena T-650 User Manual
Page 10
GETTING ACQUAINTED
Power and Control Connections View
1
Safety Stop Input and Jumper – (SAFETY STOP) The safety circuit from other
external devices can be connected here. When this input is opened the tabber will stop.
Important! If an external safety circuit is not being connected to this input, then the Jumper Plug
(supplied) must be connected, or the Tabber’s transport power will not turn on.
2
Emergency Stop Output –
This connection permits the tabber to control the emergency
stop function of an external device.
3
Feeder Control Connection – (FEEDER) This connection allows the tabber to
start/stop the feeder. An appropriate cable and feeder must be used.
4
Main Power Switch – This switch is used to turn the tabber On and Off.
5
Fuse – The main fuse (2.5A / 250V) for the tabber is located here.
Caution! Disconnect power before replacing fuse.
6
Power Inlet Connection – The power cord is connected here. 115V AC 50/60 Hz
T-650 Operations REV. 8/25/2010
10