Rena T-650 - Manual (Page 79)

OPERATION
18. The Select Option screen will appear.
Select Pitch.
NOTE: Whether programming
manually or automatically you must set
the pitch to ensure good registration of
the tab.
19. The Pitch of the tab is the distance
measured from the top of one tab to the
top of the next tab.
Measure the pitch of the stock you are
using and add 001”.
In this case it was 1.630, plus 0.01” for
a total of 1.640”.
Enter the pitch value using the number
keys on the Control Panel and then pressing the
Save key.
20. Press BACK one time to return to the
Select Option screen.
21. Select Position from this screen.
22. The Select Tab Offset screen will appear.
The position (offset value) for each of
the tabs, being applied by Head 2, must
be entered individually.
The position of the tab is measured
from the lead edge of the piece (the
exit end) separately. Begin by
measuring the piece length and
deciding where the first tab will be
placed.
Press Tab 1.
T-650 Operations REV. 8/25/2010 79