Rena T-650 - Manual (Page 24)

MECHANICAL SETUP
8. Close the Exit Roller Assembly and lock the two latches to secure it.
9. Release the Emergency Stop button. Turn ON the Tabber’s main power switch. Press the
green Transport Power button. Verify that the feeder is still turned OFF at this time.
Verify that the feeder interface cable is attached between the tabber and feeder. Verify
that the feeder has been aligned properly with the tabber.
10. If you have not programmed the tabber for the tabbing job, please refer to the section
“ Menu Features and Job Programming ”, for instructions. Once complete, return to this
procedure.
11. Press the soft key labeled
“Operate” to put the tabber
in the operate mode. The
screen will change to the
operating mode as shown to
the right.
12. Press the “Run” key on the
Control Panel to start the
tabber transport. The screen
will display the status of the
tabber, as shown to the right.
13. Set the feeder speed to zero and then turn the Feeder ON.
Using the feeder’s jog button, feed two pieces of media into the tabber.
14. Check the positioning of the tab or tabs
on the second piece.
The Head 1 Fine Adjustment Knob (1)
can be used to make
small corrections to
the fold position of
the tabs being
applied by Head 1.
See section titled “
Tab Positioning Adjustments (Fine Adjustments) ” for more details.
T-650 Operations REV. 8/25/2010 24