Rena T-650 - Manual (Page 96)

OPERATOR MAINTENANCE
SECTION 5 – Operator Maintenance
This section describes maintenance that an experienced operator can perform. If service or
maintenance is needed, beyond what is described in this document, please contact your local
Rena dealer to obtain service and support for your tabber.
Service should only be performed by a qualified Rena service person.
To locate a Rena dealer in your area, please click on the following link and fill out the form.
http://www.renausa.com/dealerlocator.asp
Cleaning
WARNING
THE TABBER IS A PRECISION MACHINE THAT SHOULD BE CLEANED
REGULARLY TO INSURE MANY YEARS OF SERVICE. BEFORE PERFORMING
ANY MAINTENANCE, DISCONNECT IT FROM ITS POWER SOURCE!
The Tabber must be cleaned regularly of accumulated paper dust and ink. Depending on the
types of media that are run, paper dust may accumulate within machines and on the transport.
Before cleaning unplug the power cord from the unit.
The internal areas are best cleaned with a vacuum that has a soft brush attachment to help loosen
the dust particles.
The exterior of the machine may be cleaned with any standard household cleaner, which is non-
abrasive and does not contain plastic harming solvents.
CAUTION
NEVER SPRAY OR POUR CLEANERS DIRECTLY ON OR INTO THE TABBER.
EXCESS LIQUID COULD HARM ELECTRONIC PARTS. ALWAYS DAMPEN A
RAG WITH THE CLEANER AND APPLY IT TO THE PARTS TO BE CLEANED.
Rollers and Transport belts
The belts and rollers can become glazed with paper lint and ink from the media. They should be
regularly cleaned with a mild abrasive household cleaner on a damp cloth.
Avoid using solvents on the rubber rollers.
Shafts with Movable Parts
Exposed shafts, with movable parts, should be cleaned with a soft dry cloth.
CAUTION
THE BEARINGS ON THE MOVING PARTS SUCH AS TAB HEAD 1
AND THE TRANSPORT BELT ASSEMBLIES ARE OIL-FREE NYLON.
DO NOT PUT ANY SOLVENTS OR OIL ON THEIR SURFACES.
T-650 Operations REV. 8/25/2010 96