Rena T-650 - Manual (Page 63)

OPERATION
25. The Enter Offset for Tab 1 screen will
appear. This feature is used to position
the tab on the mail piece. All
measurements are referenced from the
leading edge of the media to the
leading edge of the tab.
In this case we will be placing the tab
at the center of the piece. If the piece
is 10.5” long and we wish to place the tab 0.90” from the leading edge we would enter
0.90”.
Using the number keys, enter the desired “offset” value for Tab 1 and then press the
Save key.
26. Press the BACK button.
The Select Option screen will reappear.
Test the tab placement position.
Turn on the Transport Power and press the RUN button.
Feed at least two pieces.
Press the STOP key and check the position of the tab on the second piece.
If a position adjustment is needed, repeat from Step 24 above.
NOTE: Placement of tab on first piece may not be accurate due to manual adjustment
of stamp position in relationship to peel point.
Tip: If you find that the application position of Tab 1 is different than the offset value
you set; first recheck tabber setup (mechanical and programming). After recheck; if
the placement is still off”, see sections titled “
Operation Check-List ” and “ Tab
Positioning Adjustments (Fine Adjustments) ”.
T-650 Operations REV. 8/25/2010 63