Rena T-650 - Manual (Page 42)

OPERATION
If any of the Tab n (Tab 1, Tab 2, Tab 3) soft
keys are selected, you will be asked to enter the
offset value for the Tab number you selected.
In the following example, the number of tabs
was set to 3 and Tab 1 was selected.
NOTE: The number of Tab n choices, you are
presented with, is based off the “# Tabs” and the “tab placement” (separate, together), that
you previously selected.
If # Tabs was set to 1 or tab placement “together” was selected; you will be prompted to
“Enter Offset for Tab1…”, as soon you press the
Position key.
Enter the desired offset value for Tab n, using
the numeric keypad.
Then press the SAVE button.
Press BACK.
Repeat this process for each tab position.
Select tab offset to edit
Status: Head #n Manual Setup.
Tab 1 Tab 2 Tab 3 EXIT
Enter Offset for Tab1 and press SAVE key:
0.0”
Current Value: 4.000”
EXIT
Select option to edit, or
Press RUN to tab using Job 1.
Status: Head #n Manual Setup
# Tabs Position Pitch BACK
If the Pitch soft key is pressed.
The display will prompt you to “Enter tab pitch
and press SAVE key”.
Pitch = distance from top of tab/stamp to top of
next tab/stamp, or distance from top of black bar
to top of next black bar, plus 0.010”.
Important! This value should be set 0.010
inches larger than actual measured value.
See the section titled “ Tab/Stamp Pitch Adjustment ”
for more details.
Enter the Tab/Stamp Pitch, using the numeric
keypad.
Then press the SAVE button
ƒ
BACK – Brings you back to the previous screen.
Enter tab pitch and press SAVE key.
0.0” Current Value: 1.010”
Status: Head #n Manual Setup
BACK
T-650 Operations REV. 8/25/2010 42