Rena T-650 - Manual (Page 44)

OPERATION
If Side Tab is selected the following choices will
appear.
Select option to edit, or
Press RUN to tab using Job 1.
Status: Head #n Automatic Setup
Side Tab None BACK
ƒ # Tabs – Select this choice to choose the number
of tabs you would like to apply to the media with
the selected head.
ƒ
Product-L – Select this choice to set the paper
length of the media you are using.
Select option to edit, or
Press RUN to tab using Job 1.
Status: Head #n Automatic Setup
# Tabs Product-L Pitch BACK
ƒ
Pitch – Select this choice to set tab pitch
(distance from the top of one tab/stamp, to the
top of the next tab/stamp) for the tab/stamp stock
used on the selected head.
ƒ
BACK – Brings you back to the previous
screen.
If the # Tabs soft key is pressed.
The display will prompt you to select the
number of tabs/stamps you would like applied to
the mail piece, with the selected hea
Select option to edit, or
Press RUN to tab using Job 1.
Status: Head #n Automatic Setup
# Tabs Product-L Pitch BACK
d.
gth.
ƒ 1 – Selects one tab/stamp
ƒ 2 – Selects two tabs/stamps
ƒ 3 – Selects three tabs/stamps
Press 1, 2 or 3 for the number of tabs.
Current Value: 2
Status: Head #n Automatic Setup
1 2 3 BACK
ƒ
BACK – Brings you back to the previous
screen.
If the Product-L soft key is pressed.
The following choices will be displayed.
Select option to edit, or
Press RUN to tab using Job 1.
Status: Head #n Automatic Setup
# Tabs Product-L Pitch BACK
Enter Product Length and press SAVE key
0.0” Current Value: 11.000”
Status: Head #n Automatic Setup
Automatic BACK
ƒ
BACK – Brings you back to the previous
screen.
ƒ Automatic – Use this feature to let the
tabber automatically measure and set the
piece len
It is highly recommended that you use the
Automatic feature in order to verify proper
media feeding and sensing.
IMPORTANT: Before pressing the Automatic
soft key, make sure the feeder is turned OFF and
the Tabber’s transport power switch is turned
ON.
T-650 Operations REV. 8/25/2010 44