Rena T-650 - Manual (Page 83)

OPERATION
43. Press the BACK button 3 times to
return to the Select Tabber Head
screen.
By stopping on this screen you can run
the job or easily return to the head that
requires adjustment.
44. Verify that the Exit Roller Assembly is closed and locked.
45. Verify that both Pressure Roller Release Latches have been lowered (pressure engaged).
Test tab placement.
Turn on the Transport Power and press the RUN button.
Feed at least two pieces.
Press the STOP key and check the position of the tabs on the second piece.
NOTE: Placement of tabs on first piece may not be accurate due to manual adjustment of
tab position in relationship to peel point.
Tip: If you find that the application position of the tabs is different than the offset value
you set; first recheck tabber setup (mechanical and programming). After recheck; if the
placement is still off”, see sections titled “
Operation Check-List ” and “ Tab Positioning
Adjustments (Fine Adjustments) ”.
T-650 Operations REV. 8/25/2010 83