Rena T-650 - Manual (Page 25)

MECHANICAL SETUP
15. When you are satisfied with tab-positioning; set the tabber transport for the desired speed,
using the Speed Control Dial. Then set the speed of the feeder so that there is about a 2
inch gap between pieces; as they feed through the tabber.
Tip: If you want to test piece transport without applying tabs, you can press the STOP
button on the tabber, then press the soft key labeled “Pass-thru” to set the tabber in the
Pass-Thru mode. Press RUN to test the system without applying tabs.
16. Adjust the Head Position Minder against Head 1 and tighten
the knob.
This device will mark the location of Head 1 to make the
process of loading new tab rolls easier. When loading new
rolls of tabs onto the heads, it is more convenient if you slide
Head 1 close to the operator side of the unit; providing more
room between the heads.
After loading new tab rolls; you can simply slide Head 1
back, until it meets the Head Position Minder. Head 1 has
now been returned to its original location and you are ready to continue tabbing.
17. Head 1 setup is complete. If you will only be applying tabs with Head 1 you should
proceed to the “ Operation ” section. NOTE: Please be sure you have disabled Head 2.
If you will be applying tabs with Head 2, proceed to the section titled “Head 2
Adjustment – Side Tabbing” .
T-650 Operations REV. 8/25/2010 25