Rena T-650 - Manual (Page 111)

APPENDIX
Side Tabbing Narrow Media
Example: Applying one, two, or three tabs to the side of an 8.5 x 11 Tri-folded piece (8.5”L x
3.66” W).
The addition of the Narrow Media Guide allows side tabbing of media widths from 3.25” to 5”.
Note: Without this guide installed the minimum media width for side tabbing is 5”.
1. Remove the Side Rail (1) from the Narrow Media Guide Assembly.
2. Raise the T-650’s Media Thickness Adjustment (14) to the highest setting.
3. Remove the Center Support Plate (6) from the T-650.
4. Install the Narrow Media Guide Assembly in place of the Center Support Plate, as shown
below.
5. Position (slide) the Narrow Media Guide Assembly, closer to or farther away from the
Left Media Guide Assembly (7), in order to accommodate the width of your media.
6. Move the Right Media Guide Assembly (5) against the Narrow Media Guide Assembly,
to hold it in place.
Important: When moving the Right Media Guide Assembly (5) the transport must be
turning at a medium speed. Move guide slowly to avoid damage.
7. Reposition the Media Hold-down Guide as shown below.
8. Set up the Tabber to side tab from Head 2. See T-650 Operations Manual for details.
9. Readjust the Media Thickness Adjustment (14) to accommodate your media.
10. Run the Job.
Media Hold-down
Guide
ENTRANCE VIEW EXIT VIEW
T-650 Operations REV. 8/25/2010 111