Rena T-650 - Manual (Page 90)

OPERATION
SECTION 4 – Operation
Operation Check-List
The following check-list should be referenced before you start operating the tabber or if you are
having a problem with tabber operation.
Tabber and Feeder are mechanically setup to properly transport your media.
o Right Media Guide Assembly is adjusted to accommodate width of media
o Tabber’s Media Thickness setting is adjusted to accommodate media.
o Exit Foot repositioned against Right Media Guide Assy.
o Media feeds without hesitation or skew, using Pass-Thru mode.
o Speed of tabber and feeder adjusted so a 2” gap or more is generated between
each piece.
Peel Plate properly positioned for your application (side tab/stamp or front tab).
Tabs/Stamps properly loaded/threaded, on both heads.
o Tab web threaded behind Reel Brake Roller arm.
o Pressure Rollers Release Latch is lowered (pressure engaged) on both heads.
Job properly programmed.
o Desired Job number has been selected.
o V-Tab (tab sensor adjustments) values set for current tab/stamp stock.
o Tab Pitch set for current tab/stamp stock.
o Product (media) length has been set accurately (when using Automatic Setup).
o Desired positions (offset values) set for Tabs/Stamps.
o Unused Head was turned off (disabled) in menu.
Exit Roller Assembly closed and locked (latched)
Power Cord is plugged into wall outlet and tabber.
Main Power Switch ON.
Feeder ON.
Emergency Stop Button released.
Safety Stop Input Jumper Plug installed.
T-650 Operations REV. 8/25/2010 90