Rena T-650 - Manual (Page 6)

GETTING ACQUAINTED
SECTION 1 – Getting Acquainted
Safety Precautions ”
THIS EQUIPMENT PRESENTS NO PROBLEM WHEN USED PROPERLY. OBSERVE
THE FOLLOWING SAFETY RULES WHEN OPERATING THE RENA T-650 TABBER
AND STAMP AFFIXER.
BEFORE USING THE T-650, YOU SHOULD READ THIS MANUAL CAREFULLY AND
FOLLOW THE RECOMMENDED PROCEDURES, SAFETY WARNINGS, AND
INSTRUCTIONS:
9 Keep hands, hair, and clothing clear of rollers and other moving parts.
9 Avoid touching moving parts or materials while the machine is in use. Before clearing a jam, be sure machine
mechanisms come to a stop.
9 Always turn off the machine before making adjustments, cleaning the machine, or performing any maintenance
covered in this manual.
9 Use the power cord supplied with the machine and plug it into a properly grounded wall outlet located near the
machine and easily accessible. Failure to properly ground the machine can result in sever personal injury and/or
fire.
9 The power cord and wall plug is the primary means of disconnecting the machine for the power supply.
9 DO NOT use an adapter plug on the line cord or wall outlet.
9 DO NOT remove the ground pin from the line cord.
9 DO NOT route the power cord over sharp edges or trapped between furniture.
9 Avoid using wall outlets controlled by wall switches, or shared with other equipment.
9 Make sure there is no strain on the power cord caused by jamming between the equipment, walls or furniture.
9 DO NOT remove covers. Covers enclose hazardous parts that should be accessed by a qualified service
representative. Report any damage of covers to your service representative.
9 This machine requires periodic maintenance. Contact your authorized service representative for required
service schedules.
9 To prevent overheating, do not cover the vent openings.
9 Use this equipment only for its intended purpose.
In addition, follow any specific occupational safety and health standards for your workplace or area.
This manual is intended solely for the use and information of Rena Systems Inc., its designated agents, customers, and their
employees. The information in this guide was obtained from several different sources that are deemed reliable by all industry
standards. To the best of our knowledge, that information is accurate in all respects. However, neither Rena Systems Inc. nor
any of its agents or employees shall be responsible for any inaccuracies contained herein.
RENA Systems Inc.
and “The Envelope Imaging Company” are registered trademarks of Rena Systems Inc.
All other trademarks are the property of their respective holders.
All rights reserved. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying, recording, or any information storage and retrieval system, without permission in writing
from Rena Systems Inc.
T-650 Operations REV. 8/25/2010 6