Rena T-650 - Manual (Page 66)

OPERATION
IMPORTANT
BEFORE ATTEMPTING TO PROGRAM ANY JOB, SET UP THE FEEDER
AND THE TABBER TO FEED THE MEDIA. THEN PROGRAM THE JOB.
To place tabs on opposite sides of the mail piece, both tabbing Heads will be used.
In this example Head1 will be used to place a single tab on one side of the mail piece and Head 2
will place two tabs on the other side.
In the example below we will use the Manual Setup method to get the precise locations for the
tabs according to USPS regulations. We will setup Head 2 first, then Head 1.
1. Verify that Head 1 has been mechanically setup to perform “side tabbing”. See Section
“ Head 1 Adjustment – Side Tabbing ”.
2. Verify that Head 2 has been mechanically setup to perform “side tabbing”. See Section
“ Head 2 Adjustment – Side Tabbing ”.
3. Open the Exit Roller Assembly.
4. Verify that the Peel Plate on Head 1 is set to the Side Tabbing Application position.
5. To begin programming; select Job #
from the Run screen.
6. The Select Saved Job screen will
appear.
Select the Job number you would like
to edit.
In this case we will select Job 3.
7. The Select Setup Option screen will
appear.
Select V-Tab.
T-650 Operations REV. 8/25/2010 66