Rena T-650 - Manual (Page 113)

APPENDIX
Applying Tabs to Perpendicular Sides of Narrow Media
Example: Applying two tabs to the side and one tab to the front edge of the media.
The addition of the narrow media guide allows tabbing to perpendicular sides of media widths
from 5.25” to 6.5”.
Note: The minimum media width is 6.5”; when applying 1.5” tab at center of lead edge.
In this case the narrow media guide assembly is not used.
1. If the Side Rail (1) is not installed on the Narrow Media Guide Assembly; install it now.
2. Raise the T-650’s Media Thickness Adjustment (14) to the highest setting.
3. Make sure the Center Support Plate (6) is installed.
4. Install the Narrow Media Guide Assembly to the right of the Center Support Plate, as
shown below.
Tip: If there isn’t enough room to install the Narrow Media Guide Assembly between the
Center Support Plate and Right Media Guide Assembly (5), to install the Narrow Media
Guide, move the Right Media Guide Assembly (5) closer to the operator side of the
tabber.
Important: When moving the Right Media Guide Assembly (5) the transport must be
turning at a medium speed. Move guide slowly to avoid damage.
5. Position (slide) the Narrow Media Guide Assembly, closer to or farther away from the
Left Media Guide Assembly (7), in order to accommodate the width of your media.
6. Move the Right Media Guide Assembly (5) against the Narrow Media Guide Assembly,
to hold it in place. Important: When moving the H1 Paper Guide the transport must be
turning at a medium speed. Move guide slowly to avoid damage.
7. Reposition the Media Hold-down Guide as shown below.
8. Set up the Tabber to apply two tabs to the side of the media with Head 2 and one tab to
the front of the media with Head 1. See T-650 Operations Manual for details.
9. Readjust the Media Thickness Adjustment (14) to accommodate your media.
10. Run the Job.
Media Hold-down
Guide
ENTRANCE VIEW EXIT VIEW
T-650 Operations REV. 8/25/2010 113