Rena T-650 - Manual (Page 26)

MECHANICAL SETUP
Head 1 Adjustment – Front Tabbing
This procedure will walk you through the process of adjusting Head 1 for Front Tabbing (lead
edge tab, front tab).
NOTICE! When lead edge tabbing (front tabbing) media that is under 6.5” in width; please see
“
Appendix D- Narrow Media Guide Assembly ” for additional setup instructions.
1. Adjust the tab applicator’s Peel Plate to the proper position for “front tabbing”.
IMPORTANT! The position of the Peel Plate is critical. Always check this when you
change Head 1 from Side Tabbing to Front Tabbing.
2. Unlatch the Exit Roller Assembly and swing it open.
3. Lift the tab drive Pressure Roller Release Latch on
Head 1, to release the pressure between the tab stock
and the Tab Drive Roller.
T-650 Operations REV. 8/25/2010 26