Head 2 adjustment – side tabbing, Unlatch the exit roller assembly and swing it open, Ection titled – Rena T-650 User Manual
Page 32: Head 2, Adjustment – side tabbing
MECHANICAL SETUP
Head 2 Adjustment – Side Tabbing
This procedure will walk you through the process of adjusting Head 2 for Side Tabbing.
1. Unlatch the Exit Roller Assembly and swing it open.
2. Lift the tab drive Pressure Roller Release Latch on
Head 2, to release the pressure between the tab stock
and the Tab Drive Roller.
3. Pull on the backing untill a tab is starting to
protrude from the appllicator (peel point).
4. Lower the pressure roller release latch.
NOTE: This image shows how the center
point of the tab should align with the exit end
of the Left Media Guide Assembly. Please
note that the tab in this image is protruding
further than necessary. When initially
adjustint the tab starting point, the tab should
just starts to protrude from the applicator..
T-650 Operations REV. 8/25/2010
32