Rena T-650 - Manual (Page 16)

MECHANICAL SETUP
SECTION 3- Mechanical Setup
The T-650 is capable of applying up to three tabs, on both sides of the media, in one pass. The
T-650 is also capable of applying up to three tabs to one side of the media, while applying a
single tab to the leading edge of the media or up to three stamps to the other side of the media.
The steps required to set-up the T-650, mechanically, for applying tabs or stamps are:
•
Determine the type of tabbing or stamping application (side tab, front tab, etc…)
•
Determining the orientation that the media must feed to accommodate the application.
•
Set up the T-650 mechanically, to accommodate the media.
•
Adjust the Peel Plate position (side tab or front tab) for the application.
•
Load tabs or stamps onto the appropriate head or heads.
•
Set up the feeder and align with the tabber.
WARNING
BEFORE LOADING TABS OR STAMPS TURN OFF THE TABBER OR PRESS THE
EMERGENCY STOP BUTTON TO PREVENT THE TAB DRIVER ROLLER FROM
TURNING DURING THE LOADING PROCESS
T-650 Operations REV. 8/25/2010 16