Rena T-650 - Manual (Page 52)

OPERATION
Tab/Stamp Pitch Adjustment
1. From the Run screen press Job#.
2. Select the Job number you would like to edit.
3. Select Manual or Automatic.
4. Select Head #1 then Tab/Stamp, or Head #2 Tab then Side Tab.
5. The Select Option screen will re-
appear.
Select Pitch.
NOTE: Whether programming
manually or automatically you must
set the pitch manually to ensure good
registration of the tab.
The Pitch of the tab/stamp is the
distance measured from the top of one
stamp to the top of the next tab/stamp.
Measure the pitch of the stock you are
using and add 0.01”.
In this case it was 1.00” plus 0.01” for
a total of 1.01”.
Enter the pitch value using the number keys on
the Control Panel and then pressing the Save key.
T-650 Operations REV. 8/25/2010 52