Rena T-650 - Manual (Page 102)

TROUBLESHOOTING
SECTION 6 – Troubleshooting
The following trouble-shooting guide is provided to assist you in solving any problems that
might occur with the T-650 Tabber. We have tried to make it as complete as possible.
If you are experiencing a problem with the operation or function of the tabber. Please refer to the
“
Operation Check-List ” section as well as this “Troubleshooting” section.
Jams
CONDITION SOLUTION
Media jams in transport section of
Tabber. 1. Check alignment of Feeder to Tabber.
Media should feed between the Media
Guides.
2. Check that the Media Hold-down guide is
not pressing down too firmly on the
media. This will cause media to hesitate
or skew.
3. Check that the Media Guides are not set
too tight (too close together) or the media
may stall or hesitate as if feeds.
4. Check that the Media Thickness
adjustment is not too tight or too loose.
5. Look for obstructions in the feed path
(paper, tabs, etc…).
Tabs jam in tab wrap guides. Clean the Tab Wrap Guides. See
Operator Maintenance Section.
Side Tab Tears and does not seal to the
bottom of the piece. Media or tab may
jam in tabber. Tab or media may be
wrinkled. 1. Media Guides are set too tight against the
media; not allowing additional width of
tab on media to pass through system.
Move the Right Media Guide out
(toward the operator side) a little.
2. Placing too much tab on bottom side of
the media. Maximum tab wrap on bottom
side of media is ¾”. Reduce the amount
of tab being applied to the bottom side of
the media.
T-650 Operations REV. 8/25/2010 102