Rena T-650 - Manual (Page 91)

OPERATION
Sequence of Operation
The proper sequence for starting the T-650 is a follows:
1. Turn on the tabber using the
Main Power Switch, located
on the rear left side of the
T-650
2
12 7 6 8 9 11 5
4 1 3
.
2. Check that the Emergency
Stop Button (12) is in the
released or operate position.
3. Press the Green Transport
Power Switch (1) on the
T-650 Control Panel.
10
IMPORTANT
IF YOU ARE USING THE OPTIONAL FEEDER MAKE SURE THAT THE
INTERFACE CABLE IS CONNECTED
4. Press the RUN key (7) located below the soft keys on the Control Panel to start the
tabber. Adjust the Speed Control (5) to set the speed of the Tabber.
5. Turn on the feeder and set the media delivery speed so it is slower than tabber transport.
IMPORTANT
THE MAXIMUM SPEED OF THE T-650 TABBER IS CONTROLLED BY THE
TABBERS SOFTWARE. THE SPEED OF THE TABBER FOR APPLYING SINGLE
TABS TO ONE SIDE OF A PIECE IS 20,000 PIECES PER HOUR, FOR APPLYING
DOUBLE TABS TO ONE SIDE OF A PIECE IT IS 12,000 PIECES PER HOUR AND
FOR APPLYING TRIPLE TABS TO ONE SIDE OF A PIECE IS 8, 000 PIECES
PER HOUR. EXCEEDING THESE SPEEDS WILL CAUSE THE TABBER TO
STOP.
6. Press the STOP key () located below the soft keys to stop the tabber. Pressing the large
Emergency Stop button (12) will shut down the entire tabber and lock out the other keys.
To restart from an Emergency Stop your must release the button by turning it clockwise.
Then press the RUN key (7) to restart the tabber.
IMPORTANT
THE T-650 IS EQUIPPED WITH A TIME OUT FEATURE. IF THE T-650 IS LEFT
RUNNING WITHOUT FEEDING PIECES FOR MORE THAN 30 SECONDS IT WILL
SHUT DOWN. TO RESTART PRESS THE RUN KEY.
T-650 Operations REV. 8/25/2010 91