JLG X23J - X700AJ Service Manual - Manual (Page 109)

SECTION 3 - CHASSIS & TURNTABLE
3-82 – JLG Lift – 3121448
Reassembling Method
REASSEMBLY OF MOTOR SHAFT AND
CYLINDER BLOCK
1. Place the seal ring (M7) into its seat in the flanged hub
(M2).
2. Apply a coat of grease on the seal ring (M7).
3. By using the tool (ATZ.06.027) and a rubber hammer
push the seal ring (M7) against the seat shoulder.
4. Assemble the nos.2 steel balls (M3) into their seats in
the flanged hub (M2).
5. Assemble the nos.2 two speed springs (M4) into their
seats in the flanged hub (M2).