JLG X23J - X700AJ Service Manual - Manual (Page 210)

SECTION 3 - CHASSIS & TURNTABLE
3121448 – JLG Lift – 3-183
CONTROL BOX DISASSEMBLY/ASSEMBLY
Remove the control box.
PROTECTOR LENS
(If equipped)
CASE MOUNTING BRACKET
18A REGULATOR/RECTIFIER
(If equipped) 10A REGULATOR/RECTIFIER
(If equipped)
SILICON RECTIFIER
(If equipped)
SHORT
LONG
CIRCUIT PROTECTOR
(If equipped)
CONTROL PANEL
COMBINATION SWITCH
COMBINATION SWITCH
CONTROL CASE
SPECIAL SCREW
(6 x 12 mm)
WIRE BAND
TAB
ASSEMBLY:
Align the tab with the cut out in
the case mounting bracket and
the control panel.
ASSEMBLY:
Note the installation direction.
To the units connected
from the engine.
To the units connected from the engine.
COMBINATION
SWITCH NUT
COMBINATION
SWITCH WASHER
PAN SCREW
(3 x 12 mm) (2)
(If equipped)
(If equipped)
BLADE TYPE FUSE
(5A / 15A / 25A)