JLG X23J - X700AJ Service Manual - Manual (Page 174)

SECTION 3 - CHASSIS & TURNTABLE
3121448 – JLG Lift – 3-147
CARBURETOR REMOVAL/INSTALLATION
Dual element or cyclone type air cleaner:
GASOLINE IS HIGHLY FLAMMABLE AND EXPLOSIVE.YOUCAN BE
BURNED OR SERIOUSLY INJURED WHEN HANDLING FUEL.
•KEEP HEAT, SPARKS, AND FLAME AWAY. •HANDLE FUEL ONLY
OUTDOORS. •WIPE UP SPILLS IMMEDIATELY.
Turn the fuel valve lever to the OFF position.Remove the
air cleaner.
Set a commercially available tube clip to the fuel tube.
Disconnect the fuel tube from the carburetor.
Remove the drain screw of the carburetor to drain com-
pletely.
GOVERNOR ROD/THROTTLE RETURN SPRING
INSULATOR
PACKING
CARBURETOR PACKING
CARBURETOR INSULATOR
FUEL TUBE
INSTALLATION:
Before installing, clean the passage
thoroughly with compressed air.
Install the carburetor insulator with the
vent groove facing toward the carburetor.
After installing, clamp the high tension
cord to the carburetor insulator.
REMOVAL/INSTALLATION:
Pull the carburetor assembly to a point where the
groove of the throttle arm lines up with the governor
rod, and then lift the governor rod out of the hole of
the throttle arm and unhook the throttle return
spring.
Installation is in the reverse order of removal.
GOVERNOR ROD
THROTTLE
RETURN SPRING
HIGH
TENSION
CORD
B8 / D8 TUBE CLAMP
FUEL TUBE
REMOVAL/INSTALLATION:
Remove the fuel tube.
CARBURETOR
CARBURETO
R INSULATOR
B8 / D8 TUBE CLAMP