JLG X23J - X700AJ Service Manual - Manual (Page 91)

SECTION 3 - CHASSIS & TURNTABLE
3-64 – JLG Lift – 3121448
OIL DRAINING AND REPLACEMENT
11. Check that the gearbox axis is horizontal. Rotate the
gearbox housing until the plug (1) is on the bottom
of the vertical axis of the end cover.
REMOVE THE OIL PLUGS WITH CARE. WHEN THE
GEARBOX IS WARM, THE AIR INSIDE CAN BE PRES-
SURIZED AND THIS CAN CAUSE THEIR STRONGLY
EXPULSION TOWARDS THE WORKER.
12. Unscrew the plugs (1-2) and let the oil flow in a large
enough container; in order to facilitate the draining
must be oil still warm.
13. Wait a few minutes until all the oil is drained and
then proceed to screw on the plugs (1-2).
14. Proceed with the oil fill-up following the procedures
given.
NEVER MIX MINERAL OILS WITH SYNTHETIC OILS
AND VICE VERSA.
DO NOT DISPOSE OF THE OIL IN THE NATURAL ENVIRONMENT
BUT BE CAREFUL TO ELIMINATE IT IN COMPLIANCE WITH THE
RELATIVE RULES AND REGULATIONS THAT GOVERN LOCALLY.