JLG X23J - X700AJ Service Manual - Manual (Page 435)

SECTION 5 - HYDRAULICS
3121448 – JLG Lift – 5-9
Push the connector inside the hole and fix the plate
again.
Figure 5-10.
Screw off the setscrew and remove the pin.
Use a magnet to pull out the pin.
Figure 5-11.
Fix the setscrew in order to keep the air pressure.
Figure 5-12.
Blow pressurized air with caution on the connection in
order to push the sensor out of the hosing.
WHEN SLIDING THE ROD AND PISTON ASSEMBLY OUT OF THE
TUBE, PREVENT THE THREADED END OF THE TUBE FROM DAM-
AGING THE PISTON. KEEP THE ROD CENTERED WITHIN THE
TUBE TO HELP PREVENT BINDING.
Figure 5-13.
Figure 5-14.
BE CAREFUL IN THIS OPERATION IN ORDER TO AVOID TO BREAK
THE WIRE OR DAMAGE THE SENSOR.
Figure 5-15.